Modify EFI System

Because hydrogen burns hotter for a split second then cooler their after, it incinerates fuel & acts like a catalyst for more efficient burn. Because it also cools quickly thereafter, it buffers the engine parts but the drawback is that the O2 sensor is cooler & thrown off, this causes the ECU to add more fuel when not needed.

This is the reason for this circuit!

This circuit engineered for adjusting Narrow & Wide Band, One or Dual O2 sensors & variable voltage MAP/MAF sensor, this unit gets installed in the engine compartment. This is a "set-it-and-forget-it" type of unit for those who do not wish to tinker with the settings. (This unit is environmentally sealed to protect the circuit from water and heat.) Retail: $95.00

Remember: clockwise= leaner & counter clockwise= richer on the adjustments.

Finding your O2 Signal for installation

Tuning your EFI Enhancer

NOW AVAILABLE** Model #X2VF+hs

(for the on dash mounting) This unit has a very high quality LCD micro-voltmeter installed on the front panel. It has the same circuit as the other O2 enhancers, as well as an MAP enhancer AND a switch with LED to control the Hydrogen generator relay. PLEASE NOTE: All enhancers that contain a switch for the Hydrogen Generator are meant to control a RELAY that sends power to the Generator. They are NOT meant to have high current running through them. This is the safest way to send power to the Generator. You may purchase a relay in our web store. Retail:$195.00

All-In-One (100 AMP continuous PWM + DUAL O2 +MAP + Timer)

This is our brand new all in one unit. 100 AMP Continuous amp draw capability with controlled duty cycle, frequency and current limiting, for true set it and forget it operation. Dual O2 enhancers and a MAP enhancer, to cover most vehicles on the market today. This unit also includes a 0 to 4 minute delay-ON timer for those that need to delay the system start-up for engine diagnostic purposes. Retail:$350.00

Not intended to be used with Model #X2VF+hs

WARNING/Disclaimer: this device is intended for experienced installers and qualified auto mechanics only This device uses the electrolysis process to create Hydrogen gas. Hydrogen gas is EXTREMELY flammable. By purchasing this device, you agree to use or misuse the device at your own risk. Additionally, High amperage and water create an electrocution HAZARD. The electrolyte process (with ANY HHO generator) may create known and unknown chemicals and substances that are known to be caustic, toxic and or poisonous. You should always wear chemical and electrically insulated gloves when working with a HHO generator, the electrolyte and other components. It is probably illegal to dump the electrolyte in your locality as it is hazardous to the environment (treat it just as you would the electrolyte in your car battery - you wouldn't dump that in your kitchen sink would you?). Contact your local Hazardous waste handling facilities. No warranty, express or implied, is made nor should be assumed as to the suitability or performance of this device for any specific application. It is the buyer's/user's responsibility to do his/her own research and make his/her own evaluation. Use and/or misuse at your own Risk.

This web site is 90% unfunded, 10% funded by commission, we exist only to provide you with info. Please Donate so that we can continue & with more valued info in the future. Thank you for your support.